Head Harness for Ball gag system Slider Version II

BDSM Head Harness Straps, Slider Style for Ball Gags. Version II

NOTE: This head harness piece set does NOT come with a ball or ball strap for a gag.
Ball Gags are in other listing by size of ball.

The Harness is designed to be added to a ball gag and presumes you have one already or are ordering one at same time.
Let me know in notes if you want them put together before shipping if ordering together, the ball gag and harness will ship separately by default.

This version the chin strap is independent of the nose straps, so can be used by itself if desired (as shown in one of the images).

It is designed to fit any of my regular Ball gag straps size 2.5" balls or smaller. For the 4 largest sizes, please see customization below.
The straps on the harness are 3/4" wide and edged to avoid the sides cutting in. The slider portions are designed for a 3/4" wide strap, so will also work with a 1/2" wide strap.
It should work with any straight strap ball gag not exceeding a strap width of 3/4".

The Head Harness comes in four sizes Small, Medium-Small, Medium, and Large with about 1-2 inches of overlap in the various locations on the harness between versions.

For more accurate sizing, please provide at least three measurements in notes (as shown in measurement images)
#1 from a corner of the mouth to the top of the bridge of the nose
and then
#2 from there (top bridge of the nose) to the back of the head (see Measurement pictures above) or see full customization measurements below.
#3 for this version, also a measurement from the center of the gag strap to the center of the gag strap on the other side of the chin, going under the chin where you would like it.

Default if I am not given measurements is Generally:
Small is going to be about 3 to 4" for the 1st measurement, 13-15" for second, and 7.5" for the third
Medium-Small is going to be 4-5"; 14-16"; and 8.5"
Medium is going to be about 4-5" ; 16-19" ; and 8.5"
Large is going to be about 5-6" : 20-23" ; and 9.5"
Again specific measurement will result in a better product.

By default it is my regular black leather, it does not have any of the rings common to head harnesses, instead using rivets to hold the leather together. Because of the design it allows for the ball to still come off the strap and thus also the harness for cleaning if needed. Also allows for replacement of the ball or ball gag strap.

Measurements for balls for ball gags:

For which size ball is recommended (with the caveat this is only an educated guess): Ball diameter should not exceed open mouth Height measurement by more then 1/8th of an inch. Best is the diameter is at or below open mouth height. (measure bottom of top teeth to top of bottom teeth wide open).

Note: If measurement is smaller than 1.5" or 40mm, recommend ball should be 1/8" (3mm) larger. If larger than 2.5" or 60mm recommend 1/8 to 1/4" (3 to 5mm) size smaller. Reason: The smaller balls have more give, the larger balls less give. Reduce size if the gagee might have any jaw problems